Views:

This is by design. DDI 3.8 SP1 is installed on the Secondary System while the original DDI 3.8 is kept in the Primary System.

Keywords: booting from secondary system,always boot from secondary system,limitation DDI 3.8,Booting boot secondary system

Deep Discovery Inspector (DDI) 3.8 is booting from the Seconday System

Product / Version includes:

Deep Discovery Inspector3.8

Last updated: 2021/08/28

Solution ID: KA-0006489

Category: SPEC , Troubleshoot

Summary

After upgrading DDI 3.8 to DDI 3.8 SP1, DDI always boots from the Secondary System. When booting up, DDI shows the following information on the console:

Click image to enlarge.

This is by design. DDI 3.8 SP1 is installed on the Secondary System while the original DDI 3.8 is kept in the Primary System.

Was this article helpful?

Featured

Automation Center

Education Portal

Online Help Center

Service Status

TrendConnect

Deep Discovery Inspector (DDI) 3.8 is booting from the Seconday System

Deep Discovery Inspector (DDI) 3.8 is booting from the Seconday System

Product / Version includes:

Summary