This article shows you how to configure smart host to relay to our HES servers. You can do this once the outbound email scan of the domain has an "Activated" status.
Select the server you are using to get specific instructions for that server.
- Open Exchange System Manager and click on the plus sign (+) next to Connectors to see if you are already using an SMTP Connector.
Small Business Server (SBS) 2003 comes with a pre-configured SMTP Connector as shown below:
- If you need to create a new connector, right-click Connectors and select New > SMTP Connector. If a SMTP Connector already exists, right-click the SMTP connector and select Properties.
The SMTP Connector - Properties page opens.
- Name the Connector. Example: "TrendMicro Relay Connector".
- Select Forward all mail through this connector to the following smart hosts:
- EMEA: relay.hes.trendmicro.eu
- Non-EMEA: relay.hes.trendmicro.com
- Enter the HES Relay server address and click Add.
- Choose your Exchange Server and then click Add.
- Go to the Address Space tab and click Add.
- Select the following default options:
- Type = SMTP
- Email domain = *
- Cost = 1
- Connector scope = Entire organization
- Type = SMTP
- Click OK and close the Exchange System Manager.
- Restart the following services for the settings to take effect:
- Microsoft Exchange Routing Engine
- Simple Mail Transport Protocol (SMTP)
- Restart the server.
- Open the Exchange Management Console.
- Click on the plus sign (+) next to Organization Configuration.
- Select Hub Transport and click the Send Connectors tab.
- Right-click the existing Send Connector then select Properties and go to the Network tab.
- Select Route mail through the following smart hosts and click Add.
- Select Fully Qualified Domain Name (FQDN) and specify the HES relay servers:
- EMEA: relay.hes.trendmicro.eu
- Non-EMEA: relay.hes.trendmicro.com
- Click OK.
- Go to the Address Space tab and click Add.
- Add an asterisk (*) and then click OK.
- Click Apply > OK.
- Go to the Source Server tab and add your Exchange Server.
- Click Apply > OK.
-
Open the Exchange Admin Center and navigate to Mail Flow > send connectors.
Click image to enlarge
-
Click the plus (+) icon to create a new Send Connector.
Click image to enlarge
- Give the connector a name and set the type to "Internet". Click Next to continue.
- Under Network Settings, select Route mail through smart hosts.
-
Click the plus (+) icon to add the smart host address. Use the following FQDN as the smart host:
- Under the Smart host authentication section, select None.
- Save the configuration.
- From Domino Administrator, click the Configuration tab and then expand the Messaging section.
- Choose Configurations.
- Select the Configuration Settings document and then click Edit Configuration.
- Click the Router/SMTP > Basics tab.
-
For the field Relay host for messages leaving the local Internet domain, enter one of the following addresses based on your location:
- Click Save then Close.
- Reload the routing configuration to put the new setting into effect immediately. Otherwise, the change will take effect after the next Router configuration update.